
APOS Quick Operation Guide Voice over IP
AddPac Technology Proprietary & Documentation 130 - 31
Related APOS commands & structure
Configure the below parameters appropriate for the network
environment.
y Access ID: “AddPac”
y Access password: “1234”
y get DNS IP (option)
y get default-router IP (option)
To configure PPPoE network application, follow this procedure.
Step Commands Description
1
#
# config
Enter configuration commands, one per
line. End with CNTL/Z
(config)#
Enter APOS global configuration
mode.
2
(config)# interface ether0.0
(config-ether0.0)#
Enter the interface configuration
mode.
3
(config-ether0.0)# no ip address
Do not assign an IP address to the
interface.
4
(config-ether0.0)# encapsulation pppoe
Assign encapsulation type.
5
(config-ether0.0)# ppp authentication pap
callin
Assign PAP as PPPoE authentication.
6
(config-ether0.0)# ppp pap sent-username
addpac password 1234
Configure PAP User ID and Password.
In this example, the user ID is
“AddPac” and the password is
“1234”.
7
(config-ether0.0)# ppp ipcp ms-dns
Configure to get default router IP
from PPP Server.
8
(config-ether0.0)# ppp ipcp default-route
Configure to get DNS IP from PPP
Server.
9
(config-ether0.0)# exit
(config)#
Exits from the interface configuration
mode.
10
(config)# exit
#
Exits from APOS global configuration
mode.
Comentarios a estos manuales